Pool Cover Removal
Things to think About when Removing Your Pool Cover
Removing a pool cover properly is important to prevent damage to the cover and to make the process easier for you. Here are the steps to follow to remove a pool cover properly:
Things to Think About
Remove any standing water: Before removing the cover, you should remove any standing water from the top of the cover. This can be done using a pool cover pump or a siphon hose. Removing the water will make it easier to handle the cover and prevent any damage.
Remove any debris: Use a leaf blower or broom to remove any leaves, twigs, or other debris that has accumulated on top of the cover. This will prevent any debris from falling into the pool as you remove the cover.
Remove the cover anchors: If your pool cover has anchors, you should start by removing them. This can be done using a special tool or a wrench. Loosen the anchor and lift it up out of the deck. Repeat for all anchors.
Remove the cover: Once all anchors have been removed, you can start to remove the cover. Pull the cover off of the pool, folding it over itself as you go. Be careful not to drag the cover on the ground, as this can cause damage to the cover.
Clean the cover: After removing the cover, you should clean it using a pool cover cleaner or mild detergent and water. Rinse the cover thoroughly and allow it to dry completely before storing it.
Store the cover: Store the cover in a dry, cool place where it will not be exposed to sunlight or weather. Make sure the cover is folded neatly to prevent any creases or wrinkles from forming.
In conclusion, by following these steps, you can remove a pool cover properly without causing any damage to the cover or to the pool. Remember to always clean and store the cover properly to ensure that it lasts for many seasons.